Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
|||||||
| GMC V6 and V12 Engines Engine repair and rebuilding |
 |
|
|
Thread Tools |
|
#1
July 5th, 2016, 02:50 AM
|
|||
|
|||
66 351E Rebuild Questions and Part needed
I pulled my stuck 351E. Honed the bores, looks good. New standard rings installed. Need a camshaft cover mine is rusted. I got gaskets from Olsons, the head gaskets are for a 401, they are 5 inches (piston size) my 351 is standard at 4 9/16. Will the gap cause an issue?
My truck is from Washington State, Auto, ps, pb, custom cab, with chrome grill and bumper. thanks guys. Chris 
|
|
#2
July 5th, 2016, 03:59 PM
|
|||
|
|||
|
Re: 66 351E Rebuild Questions and Part needed
Gasket is fine. How much did Olsens charge? The cover should be easy enough, I have some, I am in kansas you might find one closer to home.
|
|
#3
July 5th, 2016, 04:01 PM
|
|||
|
|||
|
Re: 66 351E Rebuild Questions and Part needed
Gasket is fine. How much did Olsens charge? The cover should be easy enough, I think they are the same as 305, could be wrong, hopefully someone will correct me. I have some, I am in kansas, you might find one closer to home.
|
|
#4
July 6th, 2016, 02:52 AM
|
|||
|
|||
|
Re: 66 351E Rebuild Questions and Part needed
If I could get a cover that would be great. Send me a message on cost. Olson's charged $430 for a Head set.
|
|
#5
July 7th, 2016, 03:58 AM
|
|||
|
|||
|
Re: 66 351E Rebuild Questions and Part needed
Sent PM
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| new to group/351E V6 rebuild | Samuel | GMC V6 and V12 Engines | 4 | March 9th, 2013 09:16 PM |
| 63-66 3/4T part needed | Archiver | Previous Forum Posts | 0 | November 18th, 2011 01:00 AM |
| Clutch linkage questions - 66 GMC 351E | Archiver | Previous Forum Posts | 4 | March 31st, 2011 02:34 AM |
| Cheapest place to buy a 351E rebuild kit? | Archiver | Previous Forum Posts | 0 | December 7th, 2009 06:17 AM |
| Re: Cheapest place to buy a 351E rebuild kit? | Archiver | Previous Forum Posts | 0 | December 7th, 2009 01:27 AM |
