![]() |
![]() |
|
GMC V6 and V12 Engines Engine repair and rebuilding |
![]() |
|
Thread Tools |
#21
|
||||
|
||||
![]()
all those little pumps like that mr gasket, and edelbrock are junk. find a wallbro, or get a holley red pump # 12-801-1. takes up more room and more expensive, but a much better pump. this pump runs 7psi, if the carb wants to overflow, you might have to get a regulator. but it should be fine, most needle and seats will take 7 psi with no problem.
|
The Following User Says Thank You to ilvracn For This Useful Post: | ||
lizziemeister'sV6 (March 31st, 2025) |
#22
|
|||
|
|||
![]()
Installed a Carter M3955 fuel pump but had to drill out mounting flange holes for the larger bolts. Much better pump than the Carter M4548 but was a very tight fit...less than 1/4" clearance between bottom of pump and engine. Now have float level control. The M4548 pressure was over the top due to poor quality control. Next project is the fuel tank level sending unit. Only ones available fail due to ethanol corrosion on the ultra-low-quality potentiometer. Marvel Mystery oil extends the life but failure is inevitable along with suction filter disintegration. That's what you get for trading off American Made for all things made in China. No nation is sovereign when it depends on foreign made for its sustenance. Tried to tell others what a mistake it was...but the profit margin dominated the market to our never-ending woe.
|
The Following User Says Thank You to Oldygoody For This Useful Post: | ||
LEWISMATKIN (April 15th, 2025) |
#23
|
|||
|
|||
![]() Quote:
__________________
Jerr 1963 305 V6 1500 To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. |
#24
|
|||
|
|||
![]()
The business community sold out this country's domestic production for personal profit...don't have to make 'it' up. Lack of quality control and supply chain disruption are now facts of life.
|
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Re: [6066 GMC] 305D fuel pump and fuel rate | Archiver | Previous Forum Posts | 0 | December 15th, 2007 04:13 AM |
305D fuel pump and fuel rate | Archiver | Previous Forum Posts | 0 | December 13th, 2007 04:20 AM |
Re: [6066 GMC] 305D fuel pump and fuel rate | Archiver | Previous Forum Posts | 0 | December 13th, 2007 02:35 AM |
Fuel pump help | Archiver | Previous Forum Posts | 0 | February 2nd, 2006 12:55 AM |
Fuel pump | Archiver | Previous Forum Posts | 0 | November 8th, 2005 03:22 AM |