Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
|||||||
| General Discussion Sit down and chat with fellow members! Any topics that don't fit other categories goes here. |
 |
|
|
Thread Tools |
|
#1
March 25th, 2025, 10:27 PM
|
||||
|
||||
Lower ball joints on 1000 series
Folks:
Just replaced lower ball joints on my 1966 1000 series truck. Lower ball joints press in underneath a arm on my truck. When I removed the old ones using a loaner press from AutoZone, one had a spot weld to the a arm and the other side did not. Instructions with the press mentioned that this could be the case for some manufacturers. My question is if anyone else found such welds and are they factory or redneck engineering?? Thanks for any advice you can offer. Regards Steve New Orleans 
|
|
#2
April 3rd, 2025, 01:15 AM
|
||||
|
||||
|
Re: Lower ball joints on 1000 series
STEVE, THAT IS USUALLY DONE ONLY WHEN THE HOLE IN THE LOWER ARM IS LARGER THAN THE OUTSIDE OF THE BALL JOINT BECAUSE THE PREVIOUS INSTALLER DIDN'T KNOW HOW TO SHRINK THE METAL.
__________________
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
|
|
#3
April 4th, 2025, 04:54 PM
|
||||
|
||||
|
Re: Lower ball joints on 1000 series
Lewis:
Thanks for your response. I haven't put a weld back on it. I didn't notice any particular looseness when I put it back. Decided to just watch it and see if it has any movement. Regards Steve New Orleans
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 60 Ball Joints | Walys60 | Wheels, Tires, Suspension and Brakes | 2 | January 4th, 2021 02:45 PM |
| 66 GMC 1000 Upper Ball Joints | rennevat | Wheels, Tires, Suspension and Brakes | 0 | September 12th, 2017 10:07 PM |
| Lower ball joints and lower inners for a 61 1500 | Jmclendon | Wheels, Tires, Suspension and Brakes | 0 | August 30th, 2017 01:27 AM |
| F/S Lower Ball Joints 60-62 GMC | atomman | 1960-1966 GMC Marketplace | 1 | December 26th, 2016 06:16 PM |
| Ball Joints | Archiver | Previous Forum Posts | 0 | July 31st, 2002 01:30 AM |
