Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
|||||||
| General Discussion Sit down and chat with fellow members! Any topics that don't fit other categories goes here. |
 |
|
|
Thread Tools |
|
#1
March 18th, 2025, 02:39 AM
|
|||
|
|||
4L60E Swap
I know this is really for stock trucks but I am wondering if any of you know what to do. I am building 65 GMC c20 that my uncle had parked in a tree line 40-50 years ago planning to make it drivable again but never got to it. I have a 4L60E and the NP261 transfer case I am going to put behind a small block 350. I know they make stand alone control modules for the transmission but not sure if its the same for the transfer case or if I need a different one. I would also like them to have the wiring harness already then I don't have to run all the wires. Since it has push buttons to change between four and two wheel drive so I will need to put those somewhere. I really don't know where to start and wondered if anybody else has any idea of what to do. Thanks.
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| P/S swap | Archiver | Previous Forum Posts | 0 | February 27th, 2006 01:46 AM |
| What parts will swap? | Archiver | Previous Forum Posts | 0 | May 26th, 2003 01:24 AM |
| V-8 Swap | Archiver | Previous Forum Posts | 0 | January 16th, 2002 11:04 AM |
| Re: V-8 Swap | Archiver | Previous Forum Posts | 0 | January 16th, 2002 12:21 AM |
| Re: V-8 Swap | Archiver | Previous Forum Posts | 0 | January 16th, 2002 12:11 AM |
