Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
|||||||
| GMC V6 and V12 Engines Engine repair and rebuilding |
 |
|
|
Thread Tools |
|
#1
December 31st, 2019, 12:43 AM
|
|||
|
|||
350 to V6 Swap Tranmission Location
Have been collecting parts for my 350 to large V6 swap (stroked 478M) in my '72 K20. Have a complete 305 out of a '67 K2500 with bellhousing, cross member, etc.
The question I have is a minor one. Is the transmission mounting location in a 4X4 the same for a small block Chevy and a GMC V6? I.E., when I bolt my V6 to my SM465 and NP205, will I have to slide the whole nine yards forward to gain firewall clearance to make it fit? Will the GMC bellhousing even bolt to the SM465? (I assume it had an SM420 bolted to it, but it very well could have been a NP435 as well) 
|
|
| Bookmarks |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Re: [6066 GMC Truck] v6 engine numbers location | Archiver | Previous Forum Posts | 0 | October 20th, 2002 02:27 AM |
| v6 engine numbers location | Archiver | Previous Forum Posts | 0 | October 19th, 2002 01:30 AM |
| Re: [6066 GMC Truck] 350 swap | Archiver | Previous Forum Posts | 0 | March 17th, 2000 10:54 AM |
| 350 swap | Archiver | Previous Forum Posts | 0 | March 17th, 2000 04:02 AM |
| Re: [6066 GMC Truck] 350 swap | Archiver | Previous Forum Posts | 0 | March 17th, 2000 12:26 AM |
