![]() |
![]() |
|
General Discussion Sit down and chat with fellow members! Any topics that don't fit other categories goes here. |
![]() |
|
Thread Tools |
#11
|
|||
|
|||
![]()
Absolutely jealous of the running lights on the cab! Wish mine had them.
|
#12
|
|||
|
|||
![]()
Vern, I know. They were on there when I got it. I am going to get them working.
Steve |
#13
|
|||
|
|||
![]()
Finally got the instruments all connected up, it was a big suprise to see the idle oil pressure at 40lbs cold and the alternator putting out 15.4 volts. The fuel gauge registers and the speedo works so mission accomplished. I bought the stuff all from Amazon for less than 90$ so if it lasts it will be a killer deal. Now installing 3 sets of seat belts and will finish the trimming of the interior. Still can't get the cables routing operating the deluxe? heater system figured but what the **** it is summer now when it gets cold I'll worry about that, haha.
Well, hope all you folks are doing well. Steve |
![]() |
Bookmarks |
Thread Tools | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
New Member from Portland | flyingA66 | General Discussion | 9 | April 6th, 2015 02:20 PM |
v-6 for sale in portland | Archiver | Previous Forum Posts | 0 | December 5th, 2011 12:14 AM |
'63 GMC Portland, OR | Archiver | Previous Forum Posts | 0 | May 23rd, 2010 03:22 AM |
Need Pictures Restored 64-66 Fenderside | Archiver | Previous Forum Posts | 0 | April 23rd, 2006 03:46 AM |
Re: [6066 GMC Truck] Portland | Archiver | Previous Forum Posts | 0 | October 10th, 2000 06:21 AM |