Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
|||||||
| General Discussion Sit down and chat with fellow members! Any topics that don't fit other categories goes here. |
 |
|
|
Thread Tools |
|
#1
January 29th, 2021, 07:32 PM
|
|||
|
|||
Fuel Line Routing
Can someone confirm if this is the correct routing for the fuel line and what the 3rd penetration is for? Thanks.
(1960 GMC 4x4) 
|
|
#2
January 30th, 2021, 01:57 AM
|
||||
|
||||
|
Re: Fuel Line Routing
Sending unit and fuel pickup is one unit, so only one hole for fuel line to go to carb. (rear big hole) Other big hole is for seat belt bolt/tie down? Can't read the manual, if it says or not. Other pages of manual may show something assembled into those holes.
Last edited by AZKen; January 30th, 2021 at 04:55 AM.
|
|
#3
January 30th, 2021, 04:43 AM
|
|||
|
|||
|
Re: Fuel Line Routing
Large for hard line (fuel line) small for electrical (fuel gauge) was my guess. Can’t find anything in the manual. Went through it twice.
|
|
#4
January 30th, 2021, 04:52 AM
|
||||
|
||||
|
Re: Fuel Line Routing
Just now edited my post. The sender wire never leaves inside of cab. Travels towards drivers side, down under floor sill and along kick panel to gauge. Fuel line hole needs big grommet
The rear big hole for the gas line/grommet is the only hole in most 60-66 trucks. Last edited by AZKen; January 30th, 2021 at 05:09 PM.
|
|
| Bookmarks |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fuel Line from to Carb From Pump | donker1988 | I-6 Engines | 9 | August 16th, 2016 05:03 AM |
| Fuel Line, Tubing Bender, Green Fuel Line and Coat Hanger wire. | Archiver | Previous Forum Posts | 0 | October 29th, 2009 02:02 PM |
| Fuel line | Archiver | Previous Forum Posts | 0 | October 27th, 2009 01:44 AM |
| Re: [6066 GMC] Fuel line modifications for Holley converson? | Archiver | Previous Forum Posts | 0 | April 20th, 2005 02:10 AM |
| Fuel line modifications for Holley converson? | Archiver | Previous Forum Posts | 0 | April 19th, 2005 01:12 AM |
