Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
|||||||
| Transmissions and Rear Ends Three on the tree or four in the floor? Shift it all here. |
 |
|
|
Thread Tools |
|
#1
May 3rd, 2016, 01:25 PM
|
|||
|
|||
Rear cross Member mounts
Hay gang,
62 305 V6 with 4 speed. Working on changing out a clutch. Found the Rubber block mounts under the bell housing in bad shape. The ones that sit sideways inside a bracket bolted between the bracket and the cross member 2 ea. side. There is a long bolt that goes through a rubber block (lower mount) with a spacer through the bracket and threads into the bell housing. (Mounts are about 4" long W/ 2 holes and 2 studs) Questions: * Can I still buy these * what I am finding available is upper and lower Transmission mounts., If there was an upper mount ( between the cross Member and the bell housing mine is missing. * Will these upper and lower mounts work instead of the bracket and the stud mounts? Thanks, Mel 
|
|
| Bookmarks |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crooked Frame Cross Member Question-me too! | Archiver | Previous Forum Posts | 0 | June 29th, 2004 02:04 AM |
| Frame Cross Member Question | Archiver | Previous Forum Posts | 0 | June 29th, 2004 01:40 AM |
| Re: [6066 GMC Truck] transmission cross member | Archiver | Previous Forum Posts | 0 | March 4th, 2002 02:03 AM |
| Re: transmission cross member | Archiver | Previous Forum Posts | 0 | March 4th, 2002 01:53 AM |
| transmission cross member | Archiver | Previous Forum Posts | 0 | March 3rd, 2002 12:14 AM |
