Re: 478 for 1953 Flxible Visicoach
I don't have a facebook and I'm not inclined to drive 4000 miles for an engine... I'm going to drop the pan on this 478 and see what is damaged. If it didn't break anything other than the rod and lower block casting then I can put a rod in it and weld a plate over the hole in the block. I found some rods and a set of bearings on ePay. So new plan, fingers crossed the pistons/crank/cam/block webbing aren't chewed up. Might need a source for head gaskets if these tear beyond the copper spray treatment and everything else turns out...
Thanks guys
|