[Prowbar]

Short update: Got the truck on the road after this side of the rust repair was completed.
Also rebuilt the vent windows with new rubbers.
Have been using Goliath (David in his Goliath) the last months as a daily driver. The 478 has plenty of git up and go to keep up with traffic. Turns a lot of heads for sure.

Next project is to do the other side and replace the windshield, along with the needed rust repairs. The next phase of the project is to completely strip the truck to the bare chassis. Planning to tackle the front suspension, strip the bed and start prepping for paint. Have been doubting between the original Flame Red and Turquoise/Teal but the Turquoise is winning me over.

Some engine work is due as well, including a camshaft ground by Mike Jones and the rubber rear main seal upgrade. A reinforced clutch will be put in, along with the original rebuilt SM420 transmission with new bushings, bearings, synchro's and an upgrade to fix the annoying rattle that I've been experiencing.

Hope to start working on the truck in a month or so. Have to finish my last school assignment first.