September 23rd, 2018, 08:05 PM
|
|
-= Site Supporter =-
|
|
Join Date: May 2013
Location: Naples, NY
Truck: 1963 Custom Suburban Carryall - 95% original, all 3 seats, Mark IV A/C, PS/PB, 305E V6, Palamino Tan
Age: 71
Posts: 91
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 97
|
|
Re: Seat Belt Mounting Sites '63 Suburban
Turns out it is a rubber grommet in the earlier post, protecting a threaded hole that is bolt-ready for seatbelts. Seems to be a 7/16' 20tpi. The pics show views from above and below.
Also pictured is the doorpost; I removed the screws fastening it down and think i'll have just enough room to slip in a backing plate for a 3-point restraint. The front of the door pillar panel is firmly cemented in at the factory, and I don't want to distort the panel too much. I also think I can do the same for the outside seats in the back row, using the rear panel. I realize not that many people would go the 3-point route, but I'm kinda a safety nut, and expect to be hauling grandkids.
Brad
__________________
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
|