Re: 1962 GMC 305V6 4WD Slow DD Build - Cecilia (Pic Heavy)
Quote:
|
If you look at jonothans pic with the little arrow and you are holding the spindle nut socket. That part you are touching needs to slide out of the tube. Its held in by the outer ring you removed. Then the socket will fit inside.
|
I can't seem to pry it apart. I will soak it in PB Blaster today and give it another shot
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Quote:
|
Take a look at this pic. This groove where the screwdriver is pointing is where you need to look at the center of the hub to make sure the snap ring is removed.
Normally you need to remove both of them to get the locking hubs all the way out. You've got the large one, now we need to make sure you got the small one.
Take a peek inside the hub and see if you can see it. I drew some things on one of your pictures again. The circle identifies the outer axle shaft. The arrow is pointing to where the snap ring will be.
Jonathon
|
Thanks Jonathon. That was the first snap ring that I got off with my unknown-till-then snap-ring pliers. Total rings so far are two. Is there another one in there?
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
__________________
Step by steps:
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Some people are like slinkys. Not worth much but funny as heck when pushed down stairs.
__________________
If the women don't find you handsome, they should at least find you handy.
|