Re: 1962 GMC 305V6 4WD Slow DD Build - Cecilia (Pic Heavy)
While we have the tailshaft on the bench grab two screwdrivers and push apart the big ring by the base of the shaft. You can hold one side still with one flathead screwdriver, then push the other side away and forward on the shaft.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Once it's hooked out of the little groove it's in you can pry the shaft out.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
This is a crazy long shaft.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
For the next part I put it in a vise. The part that comes off next is just held on with friction. Bang it gently with a hammer going around and around the shaft to get it loose.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
This part here is TOUGH
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
If you have a spring tool use it here and save yourself some stress. It took me forever to wedge two screwdrivers, one sideways and one up and down, against this clamp.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Then I worked it up enough on one side that I could slip a third screwdriver under it.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
If you ever get it out of the groove you can bang it gently with a hammer to get it up the shaft. But...
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Put your hand over it when you get to the end or it'll PING! off into the sunset.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Now bang the bearing with a hammer. Go side to side or it'll get stuck.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
Old and new.
To view some links or images in this forum your post count must be 1 or greater. You currently have 0 posts. Maybe you should introduce yourself with a new topic?
__________________
Step by steps:
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Some people are like slinkys. Not worth much but funny as heck when pushed down stairs.
__________________
If the women don't find you handsome, they should at least find you handy.
|