Help with a custom cab
 

Hello, my body shop filled in the holes for my Custom badge and I could use some help with the placement
Thanks

Re: Help with a custom cab
 

I found a few pictures but hate to guess on the placement.

Re: Help with a custom cab
 

Just waiting on the bed to get back from the body shop

Re: Help with a custom cab
 

Did they fill them with body mud? Or did they weld the holes up?

Re: Help with a custom cab
 

He welded them

Re: Help with a custom cab
 

Well...that is the good news, at least. Check out the thread "calling all two tones" or posts from "Lineman", who is researching similar issues, and might have measurements (I would "eyeball it based on photos, but I'm "some kind of special").

Re: Help with a custom cab
 

Ya I have a few picture just thought someone had one and could pull a measurement

Re: Help with a custom cab
 

I can go out to my shop and measure the hole placements on my cab. I took the emblems off a while back so the holes are already exposed. Give me a day or two.

John

Re: Help with a custom cab
 

Thank you

Re: Help with a custom cab
 

The pictures should be good for you. I noticed the right hole is a bit lower than the left.

If you have any questions or need additional photos let me know.

I kept the angle of the camera as directly in front of the measuring tape as possible.

John

Re: Help with a custom cab
 

Thanks,
I think those will work great

Re: Help with a custom cab
 

Very impressed with the extra effort by Sonic65.

Re: Help with a custom cab
 

Just wanted to add that the last picture where the left hole is dead center at one inch is to illustrate the distance between both holes. The second to last picture is the distance of the left hole from the door jamb.

Re: Help with a custom cab
 

Thanks John that should work great.