6066 (1960-1966) GMC Truck Club
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

6066 (1960-1966) GMC Truck Club (https://6066gmcclub.com/index.php)
-   GMC V6 and V12 Engines (https://6066gmcclub.com/forumdisplay.php?f=9)
-   -   1967 305e V6 Fuel Pump (https://6066gmcclub.com/showthread.php?t=51586)

James May 29th, 2023 08:07 PM
Re: 1967 305e V6 Fuel Pump
 
Quote:
Originally Posted by jgpnashville (Post 77150)
A question on the water manifold - if I remove it to replace the short hose between the water pump and the manifold, where can I find the gaskets to seal the water manifold against the head? Anyone know a part # for those gaskets?
The gasket for the water manifold is part of the intake manifold gasket. However I might have some that I had cut off. I will check later and will PM you if I have them.

James May 30th, 2023 02:16 PM
Re: 1967 305e V6 Fuel Pump
 
Quote:
Originally Posted by jgpnashville (Post 77150)
A question on the water manifold - if I remove it to replace the short hose between the water pump and the manifold, where can I find the gaskets to seal the water manifold against the head? Anyone know a part # for those gaskets?
PM sent.

BobBray May 31st, 2023 06:05 AM
Re: 1967 305e V6 Fuel Pump
 
The intake manifold gaskets actually extend to the end of the heads, sealing the water block-off plates at the rear and the water crossover at the front. You can cut the ends off of new gaskets and just use the part that goes under the crossover or use silicone sealant. The part number for the 305E intake manifold is Victor-Reinz 111048201


All times are GMT +1. The time now is 08:59 AM.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.